【Abstract】 Objective To study a new method of alveolar cleft bone graft repair. Methods From April 2005to August 2006, 26 cases (30 sides) of alveolar cleft were treated with trabecular substance of self-il ium combined with the decalcified dentinal matrix of human (DDM). There were 16 males and 10 females, aged 6-12 years. Unilateral alveolar cleft was involved in 22 cases, bilateral alveolar cleft in 4 cases. All cases were accompanied by nasal wing collapse, 5 by deciduous tooth retention, 3 by malposed teeth and 1 by tooth deformity. Anterior occlusal radiographs and panoramic oral radiographs were taken to observe union and bone absorption before and after operation. Results Twenty-three patients achieved heal ing by first intention, oronasal fistulas were closed successfully. Infection occurred in one bilateral alveolar cleft case and bone tissue exposure in 2 cases. Wound healed by rinse or dressing change and inunction with MEBO. The X-ray films after operation showed bone bridge formation in the alveolar cleft. The stabil ity and continuity of body of maxilla were resumed. Four cases (6-9years old) were observed 6.5 months, 22 cases (9-12 years old ) were observed 8.6 months. According to Bergland for evaluation,the X-ray films after 3 months of operation showed 16 cases (16 sides) in class I (53.3%), 7 cases (8 sides) in class II (26.7%),2 cases (4 sides) in class III (13.3%), and 1 case(2 sides) in class IV (6.7%). The overall survival ratio of alveolar bone grafting was 93.3%, and the cl inical success ratio was 80%. Conclusion The DDM is good in alveolar cleft bone graft repair. It is better than using self-il ium only cl inically.
Objective To investigate whether combining use of platelet-rich plasma (PRP) and decalcified bone matrix (DBM) has synergistic action on promoting bone consol idation and heal ing. Methods Forty male New Zealand rabbits (weighing 2.2-2.8 kg) were randomly divided into 4 groups (n=10). The whole blood was extracted from the central aural artery and PRP was prepared with the Landesberg’s method. An 1 cm-defect was made below the tibiofibular joint of the lefttibia through osteotomy. In group A, defect was repaired by distraction osteogenesis (1 cm); in group B, defect was repaired with 0.5 cm DBM and then by distraction osteogenesis (0.5 cm); in group C, defect was repaired by distraction osteogenesis (1 cm) and local injection of 1 mL PRP; in group D, defect was repaired by 0.5 cm DBM combined with 1 mL PRP and then by distraction osteogenesis (0.5 cm). Then lengthening started at 7 days after operation, at a rate of 1 mm/day and 0.5 mm every time for 10 days (groups A and C) or for 5 days (groups B and D). After the lengthening, the consolidation was performed. The X-ray films were taken at 0, 12, 17, 27, and 37 days after operation. At 37 days after operation, the tibial specimens were harvested for Micro-CT scanning, three-dimensional reconstruction and biomechanical test. Results The X-ray films showed that new bone formation in groups B and C was obviously better than that in groups A and D at 37 days. The bone mineral density (BMD), bone mineral content (BMC), and bone volume fraction (BVF) of groups B and C were significantly higher than those of groups A and D (P lt; 0.05); the BMD and BMC of group C were significantly higher than those of group B (P lt; 0.05); the BVF had no significant difference between groups B and C (P gt; 0.05). There was no significant difference in BMD, BMC, and BVF between groups A and D (P gt; 0.05). The trabecula number (Tb.N) of group C was significantly more than that of other groups (P lt; 0.05), and the trabecula spacing (Tb.Sp) of group C was significantly smaller than that of other groups (P lt; 0.05), but no significant differencewas found among other groups (P gt; 0.05). There was no significant difference in the trabecula thickness among 4 groups (P gt; 0.05). The ultimate angular displacement had no significant difference among 4 groups (P gt; 0.05). The maximum torque of groups B and C was significantly higher than that of groups A and D (P lt; 0.05); the maximum torque of group C was significantly higher than that of group B (P lt; 0.05); no significant difference was found between groups A and D (P gt; 0.05). Conclusion In the rabbit bone defect/lengthening model, local injection of PRP can enhance bone consol idation effectively during consol idation phase. In normal distraction rate, DBM can promote bone consol idation during distraction osteogenesis. In the early stage of distraction osteogenesis, combining use of DBM and PRP can not further promote bone consolidation and healing.
OBJECTIVE: To investigate the effect of decalicified dental matrix (DDM) on healing of traumatic fracture and its side-effect. METHODS: From June 1997 to December 1998, 42 patients with closed traumatic long bone fracture (36 males and 6 females, aged from 18 to 57 years with an average of 32 years) were divided into two groups randomly; open reduction and internal fixation were carried out in all patients, but the DDM was used only in experimental group. After operation, the body temperature, ALT, and bone union time were observed and recorded. RESULTS: Following-up 1 to 3 years, the bone union time of experimental group was significantly shorter than that of control group (P lt; 0.01), there was no significant difference in the temperature and ALT changes between two groups(P gt; 0.05). No infection occurred. CONCLUSION: DDM can promote the growth of bony callus and enhance the healing of fracture. There is no side-effect.
Objective To evaluate the biomechanicalproperties and structuralcharacteristics of various composites of partially decalcified allogenic bone matrix gelatin and bone cement at different ratios. Methods According to Urist method, partially decalcified allogenic bone matrix gelatin was prepared and mixedwith bone cement at different ratios of 0, 400, 500, and 600mg/g. Then the comparisons of these composites were performed in microstructure, ultimate compression strength and ultimate bending strength properties. Results The electronic microscope showed that the bone particles and bone cement were distributed evenly in the composite, irregularly connecting by multiple points; with the increase ofbone particles and decrease of bone cement in the composite, there were more and more natural crevices, varying from 100 μm to 400 μm in width, in the biomaterials. Of all the composites with the ratios of 0, 400,500, and 600 mg/g, the measurements of ultimate compression strength were (71.7±2.0) MPa, (46.9±3.3) MPa, (39.8±4.1) MPa, and (32.2±3.4) MPa, respectively; and the measurements ofultimate bending strength were (65.0±3.4) MPa, (38.2±4.0) MPa, (33.1±4.3) MPa and (25.3±4.6) MPa, respectively. Conclusion The compositeof partially decalcified allogenic bone matrix gelatin and bone cement has a good biomechanical property and could be easily fabricated and re-shaped, which make it available to be used clinically as an idea bone graft biomaterial.
To evaluate the effect of technique combination of implant-retented titanium lattice with decalcified dental matrix (DDM) implanting. Methods Six healthy male dogs (weighing of 10-20 kg) were randomly divided into 3 groups. All the premolars were extracted on both sides of the jaw in dogs. After 2 weeks, titanium lattice and implant were implanted in the maxillary premolar region with DDM on one side (experimental group), but without on the other side (control group) of each dog. After 4, 9 and 14 weeks, respectively, 2 animals were individually killed each time, and the samples wereevaluated by general observation, X-ray examination, histological observation and histomorphometric analyses. Results General observation: Among the 6 dogs, there was no postoperative infection or death. The X-ray examination showed that the bone density of the experimental group was greater than the control group at 4 and 9 weeks, and had no significant difference as to the vicinity bone at 14 weeks. On the other hand, the density of the control group was very low under the titanium lattice and around the implant. The experimental group revealed a ridge augment of (1.93 ± 0.24) mm, and control group (-1.02 ± 1.20) mm (P lt; 0.05). Developed bone sponge could be found after 14 weeks. Histological observation showed that in the experimental group, the DDM surface was nearly absorbed at 4 weeks. A few new bones were formed at 9 weeks. The whole DDM was absorbed; the trabecular bone was thick and arranged regularly; and the intergradations of implant were observed at 14 weeks. In the control group, there were some inflammatory fibers around the neck of implant at 4 weeks. The inflammatory condition extended to the root of implant and the titanium lattice at 9 weeks. There was no newly-formed bone under the titanium lattice at 14 weeks. Histomorphometric analyses showed that the implant contact bone ratio approached 1 ∶ 1, and showed no significant difference between the new bone fragment and former bone fragment in the experimental group. Conclusion This augmentation of alveolar ridge evaluated by the study is appl icable, but further study is necessary.
Objective Tissue engineered bone (TEB) lacks of an effective and feasible method of storage and transportation. To evaluate the activity of osteogenesis and capabil ity of ectopic osteogenesis for TEB after freeze-dried treatment in vitro and in vivo and to explore a new method of preserving and transporting TEB. Methods Human bone marrow mesenchymal stem cells (hBMSCs) and decalcified bone matrix (DBM) were harvested from bone marrow and bone tissue of the healthy donators. TEB was fabricated with the 3rd passage hBMSCs and DBM, and they were frozen and dried at extremely low temperatures after 3, 5, 7, 9, 12, and 15 days of culture in vitro to obtain freeze-dried tissue engineered bone (FTEB). TEB and FTEB were observed by gross view and scanning electron microscope (SEM). Western blot was used to detect the changes of relative osteogenic cytokines, including bone morphogenetic protein 2 (BMP-2), transforming growth factor β1 (TGF-β1), and insul in-l ike growth factor 1 (IGF-1) between TEB and FTEB. The ectopic osteogenesis was evaluated by the methods of X-ray, CT score, and HE staining after TEB and FTEB were transplanted into hypodermatic space in athymic mouse. Results SEM showed that the cells had normal shape in TEB, and secretion of extracellular matrix increased with culture time; in FTEB, seeding cells were killed by the freeze-dried process, and considerable extracellular matrix were formed in the pore of DBM scaffold. The osteogenic cytokines (BMP-2, TGF-β1, and IGF-1) in TEB were not decreased after freeze-dried procedure, showing no significant difference between TEB and FTEB (P gt; 0.05) except TGF-β1 15 days after culture (P lt; 0.05). The ectopic osteogenesis was observed in TEB and FTEB groups 8 and 12 weeks after transplantation, there was no significant difference in the calcified level of grafts between TEB and FTEB groups by the analysis of X-ray and CT score. On the contrary, there was no ectopic osteogenesis in group DBM 12 weeks after operation. HE staining showed that DBM scaffold degraded and disappeared 12 weeks after operation. Conclusion The osteogenic activity of TEB and FTEB is similar, which provides a new strategy to preserve and transport TEB.
Objective To evaluate the tensile mechanical characteristics of decalcified cortical bone matrix with different thicknesses so as to provide an experimental basis for the scaffold of tissue engineering. Methods Decalcified cortical bone matrix was prepared from fresh bovine tibia with rapid decalcification techniques. Its physical characteristics including colour, texture, and so on, were observed. Then the decalcified rate was calculated. Decalcified cortical bone matrices were radially cut into sl ices with different thicknesses along longitudinal axis and divided into 4 groups: group A (100- 300 μm), group B (300-500 μm), group C (500-700 μm), and group D (700-1 000 μm). Then the sl ice specimens of each group were characterized with tensile test and histological examination. Results General observation showed that decalcified cortical bone matrix with hydrogen peroxide treatment was ivory white with good elasticity and flexibil ity. The decalcified rate was 97.6%. The tensile strength and elastic modulus of groups B, C, and D were significantly higher than those of roup A (P lt; 0.05); there was no significant difference among groups B, C, and D (P gt; 0.05). The stiffness in 4 groups increased gradually with the increasing thickness, it was significantly lower in group A than those in groups B, C, and D (P lt; 0.05), and in groups B and C than that in group D (P lt; 0.05). While there was no significant difference in ultimate strain within 4 groups (P gt; 0.05). Histologically, intact osteon was observed in every group, with an average maximum diameter of 182 μm (range, 102- 325 μm). Conclusion The mechanical properties of decalcified cortical bone matrix might depend on the integrity of the osteons. Sl ices with thickness of 300 μm or more could maintain similar mechanical properties when decalcified cortical bone matrix is used as a scaffold for tissue engineering.
The repair of the long bone defects by combined grafting of homogenous deealcified bene matrix(DBM ) with centrally enveloped vascularized periosteum Was reported as a new techniqe. Theroentgenograms,bone mineral count and histologic examination were done. The results showed thatthis method was beneficial and had better effect on prornoting healing of the long bene defeets fromone stage operation The oporative proeedure was described on deatil It was considered that the homogenous DBM ...