With the post-disaster psychological crisis has aroused wide attention, psychological first aid which can relieve psychological trauma and prevent post-traumatic disorder has been valued by many countries. However, mainly domestic psychological first aid training is simply theoretical training while its popularizing rate is low, it is urgent to learn from international experience to carry out more effective psychological first aid training. In the context of combination of medicine and industry, the paper majorly embodied virtual simulation’s potential in improving psychological intervention ability, deep learning level and self-efficacy. Furthermore, the paper analyzed and illustrated theoretical basis and function module of constructing psychological first aid training platform in detail, and prospected further improvement, which laid foundations for follow-up studies.
In this work, we investigated the influence of the bifurcation geometry of the iliac artery on the propagation properties of the pulse wave, and applied software to establish the straight bifurcation and curved bifurcation bi-directional fluid-solid coupling finite element analysis models based on the iliac artery, and compared and analyzed the influence of the bifurcation angle of the blood vessel on the propagation characteristics of the pulse wave. It was found that the bifurcation geometry had a significant effect on the pulse wave propagation in the iliac arteries, and the pressure and velocity pulse wave amplitudes predicted by these two models had a good agreement with that before the vessel bifurcation in a cardiac cycle. The curvilinear bifurcation model predicted the pulse wave amplitude to be lower and the pressure drop to be smaller after the bifurcation, which was more in line with the actual situation of the human body. In addition, the bifurcation point is accompanied by the stress concentration phenomenon in the vessel wall, and there is a transient increase in the velocity pulse waveform amplitude, which was consistent with the fact that the bifurcation site is prone to phenomena such as arterial stenosis and hardening. The preliminary results of this paper will provide some reference for the use of pulse waveforms in the diagnosis of arterial diseases.
This article describes a novel Multifunctional and Transparent Urinary System Model (MTUSM),which can be applied to anatomy teaching, operational training of clinical skills as well as simulated experiments in vitro. This model covers kidneys, ureters, bladder, prostate, male and female urethra, bracket and pedestal,etc. Based on human anatomy structure and parameters, MTUSM consists of two transparent layers i.e. transparent organic glass external layer,which constraints the internal layer and maintains shape of the model, and transparent silica gel internal layer, which possesses perfect elasticity and deformability. It is obvious that this model is preferable in simulating the structure of human urinary system by applying hierarchical fabrication. Meanwhile, the transparent design, which makes the inner structure, internal operations and experiments visual,facilitates teaching instruction and understanding. With the advantages of simple making, high-findelity, unique structure and multiple functions, this model will have a broad application prospect and great practical value.
The application of virtual simulation technology in the field of teaching has gradually received widespread attention both domestically and internationally. The National Virtual Simulation Experimental Teaching Project Shared Service Platform (iLAB-X) has emerged, providing a good platform and support for the teaching reform of experimental courses in universities. There are many difficulties in traditional experimental teaching of neurobiology. This article combines the teaching content of neurobiology experimental courses, fully explores and utilizes the virtual simulation resources of iLAB-X, and introduces the experimental teaching case design of the virtual real combination mode. It can enable students to have an immersive experience of arcane neurobiological experiments, help to understand and absorb theoretical knowledge, stimulate students’ interest and curiosity, and improve the teaching effectiveness of neurobiology experimental courses.
ObjectiveTo observe the effect of simulated microgravity on the photopic negative response (PhNR) of full-field flash ERG in adult mice.MethodsIn an experimental study, forty-eight adult male C57BL/6J mice (48 eyes) were randomly divided into model and control groups. Model mice were further divided into three subgroups of 8 each: tail-suspended for 15 days (subgroup A), tail-suspended for 30 days (subgroup B), and tail-suspended for 30 days followed by returning to normal position for 30 days (subgroup C). The three control subgroups were similarly fixed with a harness but kept in the normal position for corresponding periods of 15, 30, and 60 days. The mice were immediately examined using ERG-PhNR, flash VEP, OCT and visually-guided behavior in vivo, and subsequently sacrificed to analyze the retinal histology in vitro. PhNR amplitude was measured from baseline to PhNR trough. N1 peak-time and N1-P1 amplitude of VEP was analyzed. The escape duration was used to quantitatively evaluate the visual function of mice. In addition, inner retinal thickness was analyzed by OCT imaging. Data were compared by the independent sample t-test.ResultsPhNR amplitude in the model subgroup A was obviously lower than the corresponding control subgroup, the difference was statistically significant (t=−3.196, P＜0.01). There was no significant difference in PhNR amplitude between the model subgroup B or C and the corresponding control subgroup (t=−1.976, 0.285; P＞0.05). There was no significant difference in FVEP N1 peak-time or N1-P1 amplitude between any of the three model subgroups and the corresponding control subgroup (P＞0.05). There was no significant difference in OCT-measured inner retinal thickness between any of the three model subgroups and the corresponding control subgroup (t=−0.461, 2.073, −0.402; P＞0.05). The three model subgroups showed almost normal retinal structure, including the retinal ganglion cell, inner pexiform layer, inner nuclear layer, outer plexiform layer, outer nuclear layer, ellipsoid zone and RPE. There was no significant difference in visually-guided escape time between any of the three model subgroups and the corresponding control subgroup (t=−0.637, −0.955, 1.297; P＞0.05).ConclusionVia tail-suspension, short-term simulated microgravity can affect the PhNR of flash ERG; however, the change is reversible and does not affect visual function of mice.
To address the conflict between the “fitness” and “feasibility” of body-fitted stents, this paper investigates the impact of various smoothing design strategies on the mechanical behaviour and apposition performance of stent. Based on the three-dimensional projection method, the projection region was fitted with the least squares method (fitting orders 1–6 corresponded to models 1–6, respectively) to achieve the effect of smoothing the body-fitted stent. The simulation included the crimping and expansion process of six groups of stents in stenotic vessels with different degrees of plaque calcification. Various metrics were analyzed, including bending stiffness, stent ruggedness, area residual stenosis rate, contact area fraction, and contact volume fraction. The study findings showed that the bending stiffness, stent ruggedness, area residual stenosis rate, contact area fraction and contact volume fraction increased with the fitting order's increase. Model 1 had the smallest contact area fraction and contact volume fraction, 77.63% and 83.49% respectively, in the incompletely calcified plaque environment. In the completely calcified plaque environment, these values were 72.86% and 82.21%, respectively. Additionally, it had the worst “fitness”. Models 5 and 6 had similar values for stent ruggedness, with 32.15% and 32.38%, respectively, which indicated the worst "feasibility" for fabrication and implantation. Models 2, 3, and 4 had similar area residual stenosis rates in both plaque environments. In conclusion, it is more reasonable to obtain the body-fitted stent by using 2nd to 4th order fitting with the least squares method to the projected region. Among them, the body-fitted stent obtained by the 2nd order fitting performs better in the completely calcified environment.
A method of ultrasonic simulation based on the FIELD II software platform for carotid artery plaque was proposed according to the analysis for geometrical shape, tissue characteristics and acoustic properties of carotid artery plaques in clinic, and then a simulation system was developed by using the MATLAB graphical user interface (GUI). In the simulation and development, a three-dimensional geometric model of blood vessel with plaques was set up by using the metaball implicit surface technique, and a tissue model was established based on the scatterers with spatial position of gamma random distribution. Comparison of the statistical and geometrical characteristics from simulated ultrasound B-mode images with those based on clinical ones and preset values, the results fully demonstrated the effectiveness of the simulation methods and system.
Medical simulation teaching is a bridge course from theoretical knowledge to clinical practice. At present, the medical simulation teaching is facing many problems. The iSIM is a systematic method to optimize medical simulation teaching. It aims to maximize the effect of medical simulation teaching by various teaching methods and assistant technologies. The combination of iSIM and medical simulation teaching can develop the correct clinical thinking, improve the clinical skills and strengthen the communication skills, so as to improve the medical quality in the real clinical environment. Based on experience Center of Experimental Teaching on Clinical Skills of West China Hospital , this paper introduces how to use iSIM to optimize medical simulation teaching.
Aiming at the problem of scaffold degradation in bone tissue engineering, we studied the feasibility that controlls bone defect repair effect with the inhomogeneous structure of scaffold. The prediction model of bone defect repair which contains governing equations for bone formation and scaffold degradation was constructed on the basis of analyzing the process and main influence factors of bone repair in bone tissue engineering. The process of bone defect repair and bone structure after repairing can be predicted by combining the model with finite element method (FEM). Bone defect repair effects with homogenous and inhomogeneous scaffold were simulated respectively by using the above method. The simulation results illustrated that repair effect could be impacted by scaffold structure obviously and it can also be controlled via the inhomogeneous structure of scaffold with some feasibility.
A software and hardware platform for gait simulation and system evaluation for lower limb intelligent prosthesis is proposed and designed, in order that the wearable symmetry effect of the intelligent knee prosthesis can be quantitatively analyzed by machine test instead of human wear test. The whole-body three-dimensional gait and motion analysis system instrument, a device to collect gait data such as joint angle and stride of adults, was used for extracting simulated gait characteristic curve. Then, the gait curve was fitted based on the corresponding joint to verify the feasibility of the test platform in the experiment. Finally, the developed artificial knee prosthesis was worn on the prosthetic evaluation system to quantitatively analyze the gait symmetry effect. The results showed that there was no significant difference in gait symmetry between the developed knee joints at different speeds, which could reach more than 88%. The simulation and evaluation of the prosthetic gait have good effects on the functional simulation and evaluation of the lower limb intelligent prosthesis.